What Actually Happens at the Bench
Single club or full bag, every visit runs through the same four stops — from measurement to a printed build ticket you take home.
Measure
We log swingweight, lie angle, and length on your current clubs before anything new gets discussed.
Select
Candidate heads and shafts get pulled from the parts wall to match your numbers, not a sales target.
Bend & Build
Loft, lie, and length get set on the press, then assembled and swingweight-matched at the same bench.
Verify & Hand Off
You leave with a printed build ticket, and the finished clubs are checked against it before pickup.
What the Build Ticket Actually Tracks
Rather than being told a club "should" feel better, you watch swingweight, lie angle, and length populate on the same ticket format shown on our homepage — the exact numbers the builder is working from.
- Every candidate part measured, not just the one we expect to recommend
- Side-by-side comparison against your current setup
- A printed build ticket handed to you the same visit
- No purchase requirement — the reading is yours either way
See the Process in Person
Book a fitting and watch your own build ticket fill in, station by station.